Entering On-Board Diagnostics: Notes
WARNING: This page is about a different car, the 1993 Eagle Vision, 1993 Dodge Intrepid, and 1993 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Before entering on-board diagnostics, refer to PRETEST INSPECTION . Turn ignition off. Attach appropriate 1993 cartridge to DRB-II. Connect DRB-II to CCD bus diagnostic connector. See Figure .
- Turn all accessories off. Turn ignition on. All character positions will glow and copyright information will appear on DRB-II screen for a few seconds. Display will then change to DRB-II menu.
- If DRB-II displays an error message or if screen is blank, refer to VEHICLE COMMUNICATIONS TESTS. Always start at TEST 1A - FAULT MESSAGES .
- The following DRB-II modes can be accessed from DRB-II menu: VEHICLES TESTED, HOW TO USE, CONFIGURE and SELECT SYSTEM.