LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1994 >> Intrepid ES, 3.3 T >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 10B - Repairing Open Oil Pressure Switch Sense Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 10B - Repairing Open Oil Pressure Switch Sense Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.
  1. Disconnect oil pressure switch connector, located next to oil filer. Connect jumper wire between oil pressure switch connector terminal No. 2 (Gray wire) and ground. If oil pressure warning lamp illuminates, replace oil pressure switch. If oil pressure warning lamp does not illuminate, go to next step.
  2. Leave jumper wire connected to oil pressure switch connector terminal No. 2 (Gray wire). Disconnect instrument cluster Gray connector. Using DRB in ohmmeter mode, check resistance of instrument cluster Gray connector terminal No. 5 (Gray wire). If resistance is more than 5 ohms, repair open Gray wire. If resistance is less than 5 ohms, go to next step.
  3. Remove and inspect oil pressure warning lamp. Replace lamp if necessary. If lamp is okay, repair or replace instrument cluster as necessary. See INSTRUMENT PANEL article in ACCESSORIES/SAFETY EQUIPMENT.
scientia non olet · About LEMON Manuals