LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1994 >> Intrepid ES, 3.5 F >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 35F - Repairing Doors Fail To Lock From Any Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 35F - Repairing Doors Fail To Lock From Any Switch

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.
  1. Using DRB, read door lock switch voltage. If voltage is more than 0.2 volt, go to TEST 35G  . If voltage is less than 0.2 volt, remove door lock relay from junction block. See Figure . Junction block is located behind end cover, on left side of instrument panel. Go to next step.
  2. Using DRB, actuate door lock relay. Using DRB in voltmeter mode, check voltage on door lock relay connector terminal "C" (Orange/White wire). If voltage does not toggle from less than 1.0 volt to more than 10 volts, go to step 5). If voltage toggles from less than 1.0 volt to more than 10 volts, go to next step.
  3. Remove door unlock relay. Using DRB in ohmmeter mode, check resistance of door unlock relay connector terminal "D" (Black wire). If resistance is more than 5 ohms, repair open Black wire. If resistance is less than 5 ohms, go to next step.
  4. Using an external ohmmeter, check resistance between door unlock relay connector terminals "A" (Pink/Black wire) and "D" (Black wire). If resistance is more than 5 ohms, replace door unlock relay. If resistance is less than 5 ohms, replace door lock relay.
  5. Gain access to Body Control Module (BCM). BCM is located behind right kick panel. Leave BCM connectors connected. Using DRB in volt-meter mode, check voltage on BCM Gray connector terminal No. 18 (Orange/White wire). Using DRB actuate door lock relay. If voltage toggles between less than 1.0 volt and more than 10 volts, repair open Orange/White wire. If voltage does not toggle between less than 1.0 volt and more than 10 volts, go to next step.
  6. Turn ignition switch to OFF position. Disconnect BCM Gray connector. Disconnect Remote Keyless Entry (RKE) module. See Figure . Using DRB in ohmmeter mode, check resistance of BCM Gray connector terminal No. 18 (Orange/White wire). If resistance is less than 5 ohms, repair short to ground in Orange/White wire. If resistance is more than 5 ohms, replace BCM.
scientia non olet · About LEMON Manuals