LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1996 >> Caravan Base, 2.4 B >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul - 2.4L >> Fuel System >> Fuel Level Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Level Sensor: Removal

  1. Fuel level sensor is mounted on fuel pump module. See Figure .
  2. Remove fuel pump module. See FUEL PUMP MODULE  under FUEL SYSTEM. Depress retaining tab and disconnect electrical connector for fuel pump and fuel level sensor from electrical connector at top of fuel pump module.
  3. Remove Blue locking wedge from inside of electrical connector for fuel pump and fuel level sensor. Locking wedge fits on inside of electrical connector, near the electrical terminals.
    CAUTION: Note location of wires in electrical connector for fuel pump and fuel level sensor for installation reference. Wires must be installed in correct location.
  4. Mark wire location in electrical connector for fuel pump and fuel level sensor for installation reference. Wires for fuel level sensor must be removed from the electrical connector for fuel pump and fuel level sensor.
  5. Use small screwdriver to lift locking finger away from electrical terminal on the wire. Push wire with electrical terminal from electrical connector.
  6. Using screwdriver, pry between fuel pump module and top of fuel level sensor to release fuel level sensor from fuel pump module. Push fuel level sensor downward, toward bottom of fuel pump module. Slide fuel level sensor from fuel pump module.
scientia non olet · About LEMON Manuals