LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1996 >> Intrepid Base, 3.5 F >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Self-Diagnostic System >> Test 72A - Open Seat Belt Switch Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 72A - Open Seat Belt Switch Circuit

NOTE: For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER  section in this article. Perform TEST VER-1  VERIFICATION TEST after each repair.
CAUTION: Always turn ignition off prior to disconnecting any module connector.
  1. Disconnect left front seat belt switch connector. Connector is located on left side door pillar, just behind seat. Connect jumper wire between seat belt switch connector terminals No. 1 (Light Green/Red wire) and No. 2 (Black wire). Using scan tool, read seat belt switch status. If scan tool displays SEAT BELT: CLOSED, replace left front seat belt switch. If scan tool does not display SEAT BELT: CLOSED, go to next step.
  2. Connect jumper wire between chassis ground and seat belt switch connector terminal No. 1 (Light Green/Red wire). If scan tool displays SEAT BELT: CLOSED, repair open Black wire. If scan tool does not display SEAT BELT: CLOSED, go to next step.
  3. Access Body Control Module (BCM). BCM is located behind right kick panel. With BCM connectors connected, connect jumper wire between chassis ground and BCM Gray connector terminal No. 5 (Light Green/Red wire). If scan tool displays SEAT BELT: CLOSED, repair open Light Green/Red wire. If scan tool does not display SEAT BELT: CLOSED, replace BCM.
scientia non olet · About LEMON Manuals