Test TC-25B - Idle Air Control Motor Circuits
NOTE:
For connector terminal idnetification, see CONNECTOR IDENTIFICATION DIRECTORY table. For wiring diagram, see WIRING DIAGRAMS article.
- Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Inspect PCM connector for damaged or pushed out terminals. Repair as necessary. Perform TEST VER-2A . If PCM connector terminals are okay, go to next step.NOTE: For next step, see the IAC DRIVER IDENTIFICATION table for IAC motor wire color identification.
- Using an external ohmmeter, check resistance of IAC motor driver No. 1 wire between IAC motor connector and PCM connector terminal No. 57. If resistance is 5 ohms or more, repair open in IAC motor driver No. 1 wire. Perform TEST VER-2A . If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2A .