Vehicle Theft Security System (VTSS)

VTSS monitors vehicle doors, hood, trunk key cylinder and ignition for unauthorized operation/entry. When alarm is triggered, the horn will sound for 3 minutes and the parking lights will flash for 15-18 minutes.

When an unauthorized entry into vehicle occurs, the VTSS module signals Powertrain Control Module (PCM) via CCD bus that it is not okay to start the engine. The PCM then "zeros out" the pulse width of the fuel injectors, thus preventing the engine from starting (start/stall condition). The engine will NOT start until VTSS is disarmed.

Initialization & Verification

An initialization procedure, included in VTSS, requires that vehicle record 20 engine cranking cycles before allowing VTSS module to function. For this reason, VTSS requires verification. To verify VTSS, perform the following: Open driver's door (all others closed). Remove ignition key. Lock doors with power door lock switch. Close driver's door. If VTSS SET light flashes, system is armed and operational. If VTSS SET light does not flash, 20 engine cranking cycles have not occurred or there is a problem with VTSS.

Manual Override Mode & Tamper Alert Mode

The VTSS will not arm if the doors are locked using the key or the manual lock control (manual override mode). If horn sounds 3 times when either front door is unlocked, the alarm was activated/triggered (tamper alert mode).