LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 1996 >> Intrepid ES >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.5L >> Trouble Code Tests >> Test TC-69E - Injector No. 5 Control Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test TC-69E - Injector No. 5 Control Circuit

NOTE: For connector terminal idnetification, see CONNECTOR IDENTIFICATION DIRECTORY  table. For wiring diagram, see WIRING DIAGRAMS article.
  1. Turn ignition off. Disconnect injector No. 5 connector. Using an external ohmmeter, check resistance across injector No. 5 terminals. If resistance is 10-16 ohms, go to next step. If resistance is not 10-16 ohms, replace injector No. 5. Perform TEST VER-2A .
  2. Turn ignition on. Using scan tool, actuate ASD relay. Using scan tool in voltmeter mode, check voltage on injector No. 5 connector ASD relay output circuit Dark Green/Orange wire. If voltage cycles high and low, go to next step. If voltage does not cycle high and low, repair open ASD relay output circuit. Perform TEST VER-2A .
  3. Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Using scan tool in ohmmeter mode, check resistance of PCM connector terminal No. 15 injector No. 5 driver circuit (Brown/Red wire). If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, repair short to ground on injector No. 5 driver circuit. Perform TEST VER-2A .
  4. Using an external ohmmeter, check resistance of injector No. 5 driver circuit Brown/Red wire between PCM connector terminal No. 15 and injector No. 5 connector. If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2A . If resistance is 5 ohms or more, repair open injector No. 5 driver circuit. Perform TEST VER-2A .
scientia non olet · About LEMON Manuals