Test 3C - No Response From Body Control Module

NOTE: For connector terminal identification see CONNECTOR IDENTIFICATION . For wiring diagrams, see WIRING DIAGRAMS . Perform VERIFICATION TEST VER-1A after each repair.

CAUTION: Always turn ignition off prior to disconnecting any module connector.

Turn ignition off. Remove Body Control Module (BCM) from junction block. Junction block is located under left side of instrument panel. Turn ignition on. Using external voltmeter, measure voltage between ground and junction block internal connector, terminal No. 9. If voltage is more than 10 volts, replace BCM. If voltage is 10 volts or less, replace junction block.