Windshield Wiper Test 5A - Wiper Inoperative After Washer Used
NOTE:
Perform WINDSHIELD WIPER TEST 1A
before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE
.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Turn ignition on. If washer system works, go to next step. If washer system does not work, see WIPER/WASHER SYSTEM article.
- Using scan tool, actuate washer. If washer pump sense displays ON, replace CTM. If washer pump sense does not display ON, repair open Brown wire between CTM 14-pin Green connector "A" and multifunction switch.