Test 13C - No Response From Central Timer Module (CTM)

NOTE: For connector terminal identification see CONNECTOR IDENTIFICATION . For wiring diagrams, see WIRING DIAGRAMS . Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE .

CAUTION: Always turn ignition off prior to disconnecting any module connector.

Using external ohmmeter, measure resistance between ground and fused ignition switch output run/accy terminal (Dark Blue wire) on fuse No. 6 socket. If resistance is less than 5 ohms, repair Dark Blue wire for short to ground. Replace fuse No. 6. If resistance is 5 ohms or more, replace fuse No. 6.