Test TC-82B: Speed Control Solenoid Circuits Or Speed Control Power Relay Circuits

NOTE: Perform TEST TC-82A: SPEED CONTROL POWER RELAY OR 12-VOLT DRIVER CIRCUIT before proceeding. For connector terminal identification, see CONNECTOR IDENTIFICATION . For component location and wiring diagram, see WIRING DIAGRAMS article.

Using an external ohmmeter, check resistance of S/C brake switch output circuit (Dark Blue/Light Green wire on ZJ body; Dark Blue/Red wire on all other bodies) between brakelight switch connector and S/C servo connector. If resistance is more than 5 ohms, repair open S/C brake switch output circuit and perform TEST VER-4A: SPEED CONTROL VERIFICATION . If resistance is 5 ohms or less, go to next step.
Check brakelight switch adjustment. Adjust brakelight switch as necessary and perform TEST VER-4A: SPEED CONTROL VERIFICATION . If brakelight switch is adjusted properly, replace brakelight switch and perform TEST VER-4A: SPEED CONTROL VERIFICATION .