Engine Controls - System & Component Testing - Fwd Vans: Introduction

Before testing separate components or systems, perform procedures in BASIC DIAGNOSTIC PROCEDURES - FWD VANS article. Since many computer-controlled and monitored components set a Diagnostic Trouble Code (DTC) if they malfunction, also perform DIAGNOSTIC PROCEDURE under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS - FWD VANS article.

NOTE: References to California models apply to California emission vehicles, which may be verified by underhood Emission Control label. California emissions may be available in other states.

NOTE: Testing individual components does not isolate short or open circuits. Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use ohmmeter to isolate shorted or open wiring harness.