Specifications Index
DURANGO SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | 180 Ft. Lbs. (244 N.m) | ||
| Battery | See BATTERY SPECIFICATIONS table under CAPACITIES . | ||
| Brakes | |||
| Bleeding Sequence | |||
| With ABS | BLEEDING BRAKE SYSTEM | ||
| Without ABS | BLEEDING PROCEDURES | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | See GENERATOR APPLICATION table under DESCRIPTION | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 18-21 psi | ||
| Thermostat R & I | |||
| 4.7L | THERMOSTAT | ||
| 5.2L & 5.9L | N/A | ||
| Water Pump R & I | |||
| 4.7L | WATER PUMP | ||
| 5.2L & 5.9L | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | |||
| 4.7L | Oil pressure is 4 psi (.3 kg/cm2 ) at idle, and 25-80 psi (1.7-5.6 kg/cm2 ) at 3000 RPM with engine at normal operating temperature. | ||
| 5.2L & 5.9L | Oil pressure is 6 psi (.4 kg/cm2 ) at idle and 30-80 psi (2.1-5.6 kg/cm2 ) at 3000 RPM with engine at normal operating temperature. | ||
| Overhaul | |||
| 4.7L | ENGINE SPECIFICATIONS | ||
| 5.2L & 5.9L | ENGINE SPECIFICATIONS | ||
| Torque | |||
| 4.7L | TORQUE SPECIFICATIONS | ||
| 5.2L & 5.9L | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Drive Plate/Flex Plate Torque | |||
| 4.7L | 45 Ft. Lbs. (60 N.m) | ||
| 5.2L & 5.9L | 55 Ft. Lbs. (75 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | Fuel filter is incorporated into the fuel pressure regulator. Regulator is mounted in rubber grommet on top of fuel pump module. | ||
| Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | FUEL PUMP PRESSURE TEST | ||
| Fuel Pressure Release Procedure | FUEL PRESSURE RELEASE | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER & TIMING MARKS Wire routing is located in Figures. | ||
| Spark Plugs | SPARK PLUGS | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Lug Nut Torque | 85-115 Ft. Lbs. (115-157 N.m) | ||