Installation (Breeze, Cirrus, Sebring Convertible & Stratus)
- Install wires for fuel level sensor in bottom of fuel pump module. Place wires in groove on back side of fuel level sensor.
- While feeding wires into guide grooves, slide fuel level sensor onto channel in fuel pump module until fuel level sensor snaps into place. Ensure tab at bottom of fuel level sensor is fully engaged.
- Install each wire for fuel level sensor up through electrical connector for fuel pump and fuel level sensor. Pull each wire backward until electrical terminal on the wire locks in place. Ensure wires are installed in original location.
- Install electrical connector for fuel pump and fuel level sensor on electrical connector on bottom side of electrical connector mounted on top of fuel pump module. Reinstall fuel pump module using proper procedure. See FUEL PUMP MODULE .