LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2000 >> Intrepid Base >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation >> Fuel Systems >> Fuel Tank >> Installation (Sebring Convertible)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation (Sebring Convertible)

  1. To install, reverse removal procedure. Install fuel lines on fuel pump module using proper procedure. See FUEL LINE DISCONNECT FITTINGS .
    NOTE: Ensure grommet with fuel pump module wiring harness is properly installed in the body when raising fuel tank back into place.
  2. When raising fuel tank back into place, push grommet with fuel pump module wiring harness back into the body. Install and tighten fuel tank strap bolts to specification, starting with the front bolts and then the rear bolts. See TORQUE SPECIFICATIONS . To install remaining components, reverse removal procedure.
  3. Check for fuel leaks by starting engine or by pressurizing fuel system. Fuel system may be pressurized by using scan tool manufacturer's instructions and scan tool connected to Data Link Connector (DLC) to perform ASD FUEL SYSTEM TEST. When performing ASD FUEL SYSTEM TEST, the ASD relay and fuel pump relay remain energized for 7 minutes unless test is stopped or ignition switch is turned to OFF position.
scientia non olet · About LEMON Manuals