Powertrain Control Module: Installation

The PCM engine control strategy prevents reduced idle speeds until after engine operates for 320 km (200 miles). If PCM is replaced after 320 km (200 miles) of usage, update mileage and vehicle identification number (VIN) in new PCM. Use DRB scan tool to change mileage and VIN in PCM. If this step is not done a Diagnostic Trouble Code (DTC) may be set. Refer to appropriate Powertrain Diagnostic Manual and DRB scan tool.

1. Install three connector to PCM. Install PCM and tighten screws. Install cover and tighten screws. Connect positive battery cable at PDC and reprogram radio and clock.
2. Using DRB scan tool, program mileage and vehicle identification number (VIN) into PCM. Refer to DRB scan tool and appropriate Powertrain Diagnostic Manual.