LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2000 >> Viper RT/10 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Engine Component Tests >> On-Vehicle Service >> Fuel System Pressure Release >> Fuel Pressure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pressure

Fuel pressure should be 345-413 kPa (50-60 psi)

  1. Remove Fuel Pump relay from Power Distribution Center (PDC). For location of relay, refer to label on underside of PDC cover.
  2. Start and run engine until it stalls.
  3. Attempt restarting engine until it will no longer run.
  4. Turn ignition key to OFF position.
  5. Place a rag or towel below fuel line quick-connect fitting at fuel rail.
  6. Return fuel pump relay to PDC.
  7. One or more Diagnostic Trouble Codes (DTC's) may have been stored in PCM memory due to fuel pump relay removal. The DRBIII(R) scan tool must be used to erase a DTC.