Incomplete Latch Release - Overcurrent
NOTE:
This code may set if release switch is operated too many times in a row during door cinch operation.
NOTE:
After making any repairs, perform BODY VERIFICATION TEST
under VERIFICATION TESTS.
- Using scan tool, record and erase DTCs. Turn ignition off. Wait 10 seconds. Turn ignition on. Operate power liftgate several times if possible. Recheck for DTCs. If INCOMPLETE LATCH RELEASE - OVERCURRENT resets, go to next step. If INCOMPLETE LATCH RELEASE - OVERCURRENT does not reset, system is operating properly at this time. Check for intermittent poor connections or faulty circuits.
- Visually inspect liftgate for proper alignment, damaged strikers, damaged latches or obstructions. Repair as necessary. If possible, check operation of liftgate on a known-good vehicle. If liftgate effort is excessive, diagnose power liftgate by symptom. See TROUBLE SHOOTING in POWER SLIDING DOORS & LIFTGATE - CARAVAN, TOWN & COUNTRY, & VOYAGER article. If liftgate effort is not excessive, replace liftgate cinch/release motor. See REMOVAL & INSTALLATION in POWER SLIDING DOORS & LIFTGATE - CARAVAN, TOWN & COUNTRY, & VOYAGER article.