LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2002 >> Caravan EC >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Memory Seats >> Recliner Sensor Out Of Range High
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Recliner Sensor Out Of Range High

NOTE: After making any repairs, perform MEMORY SYSTEM VERIFICATION TEST  under VERIFICATION TESTS.
  1. Using scan tool, erase DTCs from Memory Seat/Mirror Module (MSMM). Operate driver's power seat and memory functions. Turn ignition off. Start engine and let idle for approximately one minute. Recheck for DTCs in MSMM. If RECLINER SENSOR OUT OF RANGE HIGH resets, go to next step. If RECLINER SENSOR OUT OF RANGE HIGH does not reset, conditions necessary to set this DTC are not present at this time. Check for intermittent poor connections or faulty circuits and repair as necessary. See MEMORY SYSTEMS in appropriate SYSTEM WIRING DIAGRAMS article in ELECTRICAL.
  2. Turn ignition off. Locate and disconnect driver's seat recliner sensor 3-pin connector. Recliner sensor connector has Light Green/Brown, Light Green/Light Blue and Light Green/White wires. Using DVOM, measure resistance between ground and driver's seat recliner sensor 3-pin connector terminal "C" (Light Green/Brown wire). If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, go to step  7.
  3. Using DVOM, measure voltage between ground and driver's seat recliner sensor 3-pin connector terminal "A" (Light Green/White wire). Turn ignition on. If voltage is 5.5 volts or less, go to next step. If voltage is greater than 5.5 volts, repair short to voltage in Light Green/White wire between driver's seat recliner sensor and splice located near MSMM.
  4. Turn ignition off. Locate and disconnect MSMM connectors. See COMPONENT LOCATIONS . Turn ignition on. Using DVOM, measure voltage between ground and MSMM connector C2 terminal No. 16 (Light Green/Light Blue wire). See Figure and Figure . If voltage is 0.2 volt or less, go to next step. If voltage is greater than 0.2 volt, repair short to voltage in Light Green/Light Blue wire between MSMM and driver's seat recliner sensor.
  5. Turn ignition off. Reconnect MSMM connectors. Turn ignition on. Using scan tool, monitor select BODY MEMORY SEAT SENSORS and monitor RECLINER POSITION SENSOR voltage. If voltage is greater than 0.2 volt, go to next step. If voltage is 0.2 volt or less, replace seat track assembly. See POWER SEAT POSITION ADJUSTER TRACK under REMOVAL & INSTALLATION in POWER SEATS article.
  6. Reconnect driver's seat recliner sensor 3-pin connector. Using scan tool, monitor RECLINER POSITION SENSOR voltage. Operate recliner up and down. If voltage is 7 volts or less, replace MSMM. See MEMORY SEAT/MIRROR MODULE  under REMOVAL & INSTALLATION. If voltage is greater than 7 volts when seat motor is operating, replace seat track assembly.
  7. Turn ignition off. Locate and disconnect MSMM connectors. See COMPONENT LOCATIONS . Ensure driver's seat recliner sensor 3-pin connector is disconnected. Using DVOM, measure resistance of Light Green/Brown wire between driver's seat recliner sensor 3-pin connector terminal "C" and MSMM connector C3 terminal No. 16. See Figure and Figure . If resistance is greater than 5 ohms, repair open in Light Green/Brown wire. If resistance is 5 ohms or less, replace MSMM. See MEMORY SEAT/MIRROR MODULE  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals