Right Cylinder Lock Switch Input Short
NOTE:
When this DTC is set, Vehicle Theft Security System (VTSS) indicator will stay on during VTSS arming process.
NOTE:
After making any repairs, perform BODY VERIFICATION TEST under VERIFICATION TESTS.
- Turn ignition on. Using scan tool, clear DTCs. Turn ignition off. Monitor DTCs on scan tool. Remove the key and operate right cylinder lock switch. Wait 10 seconds. If RIGHT CYLINDER LOCK SWITCH INPUT SHORT resets, go to next step. If RIGHT CYLINDER LOCK SWITCH INPUT SHORT does not reset, system is operating properly at this time. Check for intermittent poor connections or faulty circuits.
- Using scan tool, select SENSORS. Monitor RIGHT CYL SW MUX voltage. If voltage is 4.6 volts or less, go to next step. If voltage is greater than 4.6 volts, replace cylinder lock switch.
- Locate and disconnect Body Control Module (BCM) connector C3. See COMPONENT LOCATIONS . See Figure. Using DVOM, measure resistance between ground and BCM connector C3 terminal No. 15 (Violet/White wire). If resistance is 1000 ohms or less, repair short to ground in Violet/White wire between cylinder lock switch and BCM. If resistance is greater than 1000 ohms, replace BCM. See BODY CONTROL MODULE under REMOVAL & INSTALLATION.