DTC P0703: Brake Switch Sense Circuit: Notes
NOTE:
For component location, see COMPONENT LOCATIONS
. For connector terminal identification, see CONNECTOR IDENTIFICATION
. For circuit identification and wiring diagram, see appropriate WIRING DIAGRAMS article.
NOTE:
If Powertrain Control Module (PCM) is replaced, PCM must be reprogrammed. See POWERTRAIN CONTROL MODULE
under PROGRAMMING. After each repair procedure has been completed, reconnect all components and perform POWERTRAIN VERIFICATION TEST VER-4
under VERIFICATION TESTS to ensure system is functioning properly.
NOTE:
Brake switch may also be referred to as brakelight switch or brakelamp switch.