LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2003 >> Intrepid SE, 3.5 V >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Programming >> Powertrain Control Module >> Programming Powertrain Control Module
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Programming Powertrain Control Module

  1. To program PCM, connect DRBIII® scan tool to Data Link Connector (DLC). DLC is located below driver's side of instrument panel. See Figure. Place transmission in Park or Neutral. Turn the ignition on, with the engine off.
  2. Using DRBIII® scan tool, select THEFT ALARM, SKIM then MISCELLANEOUS.
  3. Select PCM REPLACED.
    4. NOTE: If 3 attempts are made to enter the secure access mode using an incorrect Personal Identification Number (PIN), secured access mode will be locked out for one hour (the vehicle will still run). To exit this lockout mode, turn the ignition switch to the RUN position for one hour then enter the correct PIN. (Ensure all accessories are turned off. Also, monitor the battery state and connect a battery charger if necessary).
  4. Enter secured access mode by entering the vehicle four-digit PIN.
  5. Press ENTER to transfer the secret key data (the SKIM will send the secret key data to the PCM).
scientia non olet · About LEMON Manuals