Quick Learn Procedure

To perform the Quick Learn Procedure, the following conditions must be met:

• The brakes must be applied.
• The engine speed must be above 500 RPM.
• The throttle angle (TPS) must be less than 3 degrees.
• The shift lever position must stay until prompted to shift to overdrive.
• The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the DRBIII® indicates the procedure is complete.
• The calculated oil temperature must be above 60° and below 200°.

1. Plug the DRBIII® scan tool into the diagnostic connector.
2. The connector is located under the instrument panel.
3. Go to the Transmission screen.
4. Go to the Miscellaneous screen.
5. Select Quick Learn Procedure. Follow the instructions of the DRBIII® to perform the Quick Learn Procedure.