LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2003 >> SRT-4 >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation >> Fuel Systems >> Fuel Level Sending Unit/Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Level Sending Unit/Sensor: Installation

  1. Install wires for fuel level sensor in bottom of fuel pump module. Place wires in groove on back side of fuel level sensor.
  2. While feeding wires into guide grooves, slide fuel level sensor onto channel in fuel pump module until fuel level sensor snaps into place. Ensure tab at bottom of fuel level sensor is fully engaged.
  3. Install each wire for fuel level sensor up through fuel pump and fuel level sensor harness connector. Pull each wire backward until terminal locks in place. Ensure wires are installed in original location.
  4. Install fuel pump and fuel level sensor harness connector to bottom side of fuel pump module harness connector. Reinstall fuel pump module using proper procedure. See FUEL PUMP MODULE .
scientia non olet · About LEMON Manuals