Specifications Index
SRT-4 SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | A/C SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | 180 Ft. Lbs. (244 N.m) | ||
| Battery | SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | |||
| With ABS | STANDARD PROCEDURE - ANTILOCK BRAKE SYSTEM BLEEDING | ||
| Without ABS | BLEEDING SEQUENCE | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | COMPONENT TESTS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | GENERATOR APPLICATION | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | ADJUSTMENTS | ||
| Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 14-18 psi | ||
| Thermostat R & I | ENGINE COOLANT THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure (CAUTION: If oil pressure is zero at curb idle, DO NOT run engine at 3000 RPM.) | Oil pressure at curb idle (minimum) is 4 psi (25 kPa). Oil pressure at 3000 RPM is 25-80 psi (170-550 kPa). | ||
| Overhaul | See appropriate Figure under 2.4L ENGINE . | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Drive Plate/Flex Plate Torque | 70 Ft. Lbs. (95 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | FUEL FILTER | ||
| Pressure Specification | FUEL PUMP | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST | ||
| Fuel Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | FIRING ORDER | ||
| Spark Plug | |||
| Type | SPARK PLUGS | ||
| Gap | .013-.001" (0.33-.038 mm) | ||
| Torque | 13 Ft. Lbs. (18 N.m) | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Lug Nut Torque | 100 Ft. Lbs. (135 N.m) | ||