LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2003 >> Viper >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System - Generators & Regulators >> Verification Tests >> Verification Test VER-3
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Verification Test VER-3

  1. Inspect the vehicle to ensure that all engine components are properly installed and connected. Reassemble and reconnect components as necessary.
  2. Connect the DRBIII(R) to the data link connector and erase the DTC's.
  3. If the PCM was not replaced, skip steps  4 - 6 then continue the verification.
  4. If the PCM was replaced, the correct VIN and mileage must be programmed or a DTC will set in the ABS and Air Bag modules.
  5. In addition, start the vehicle 20 times after the module is replaced. After 20 starts, the new PCM is in the proper in-field mode and will kill the fuel if it doesn't receive the VTA Status (J1850) message from the BCM.
  6. For ABS and Air Bag systems: Enter correct VIN and Mileage in PCM. Erase codes in ABS and Air Bag modules.
  7. Perform the generator output test.
  8. Start the engine and set the engine speed to 2000 RPM for at least 30 seconds.
  9. Allow the engine to return to idle.
  10. Cycle the ignition key OFF then ON.
  11. With the DRBIII(R), read DTC's.
  12. If any DTC's or symptoms are present at this time, check for any related TSB's and/or refer to appropriate Symptom List. If not DTC's are present repair is not complete, refer to appropriate system.
scientia non olet · About LEMON Manuals