Standard Procedure - Quick Learn Procedure

The quick learn procedure requires the use of the DRBIII® scan tool. This program allows the PCM/ TCM to recalibrate itself. This will provide the best possible transaxle operation.

• Transaxle Assembly Replacement
• Powertrain/Transmission Control Module Replacement
• Solenoid/Pressure Switch Assembly Replacement
• Clutch Plate and/or Seal Replacement
• Valve Body Replacement or Recondition

To perform the Quick Learn Procedure, the following conditions must be met:

• The brakes must be applied
• The engine speed must be above 500 rpm
• The throttle angle (TPS) must be less than 3 degrees
• The shift lever position must stay until prompted to shift to overdrive
• The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the DRBIII® indicates the procedure is complete
• The calculated oil temperature must be above 60° and below 200°
  1. Plug the DRBIII® scan tool into the diagnostic connector. The connector is located under the instrument panel.
  2. Go to the Transmission screen.
  3. Go to the Miscellaneous screen.
  4. Select Quick Learn Procedure. Follow the instructions of the DRBIII® to perform the Quick Learn Procedure.