Verification Test VER-3
NOTE:
After performing this test TRANSMISSION VERIFICATION TEST VER-1
must be performed.
NOTE:
If the PCM has been replaced and the correct VIN and mileage have not been programmed, a DTC will be set in the ABS Module, Air Bag Module and the SKIM.
NOTE:
If the vehicle is equipped with a Sentry Key Immobilizer System, Secret Key data must be updated. See PROGRAMMING
.
- Inspect the vehicle to ensure that all components related to the repair are connected properly.
- With the DRBIII(R), clear the DTC's.
- Perform generator output test.
- Start the engine and set engine speed to 2000 RPM for at least 30 seconds.
- Cycle the ignition key off and on.
- With the DRBIII(R), read the DTC's. If the DTC returns, or any other symptom or DTC is present, see appropriate symptom.
- If there are no DTC's present and all components are functioning properly, the repair is complete. If there are DTC's, repair is not complete. See appropriate symptom test. If there are no DTC's repair is complete.