Training The SKREEM
If a Sensor/Transmitter is replaced, the vehicle has to be parked for at least 15 minutes for the system to be ready to learn the new Sensor/Transmitter ID code. The vehicle then must be driven for a minimum of five minutes with a minimum continuous speed above 13 mph (20 km/h). The system will learn the new Sensor/Transmitter and clear the DTC's automatically. The Sensor/Transmitters are programmed at the assembly plant in this clockwise orientation:
- Sensor/Transmitter 1 = Left Front
- Sensor/Transmitter 2 = Right Front
- Sensor/Transmitter 3 = Right Rear
- Sensor/Transmitter 4 = Left Rear
NOTE:
- If one or all Sensor/Transmitters cannot be trained, check for and avoid RF interference.
- If one Sensor/Transmitter still cannot be trained, replace it and retry.
- If all Sensor/Transmitters still fail to train, replace the SKREEM.