Bulb-Rear A/C-Heat Control

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the rear A/C-heater control from the center floor console.
3. Use a small thin-bladed screwdriver to rotate the bulb holder (2) counterclockwise about 30 degrees to unlock it from the keyed opening in rear A/Cheater control (1) circuit board.
4. Pull the bulb holder and bulb straight out of the circuit board.

INSTALLATION

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.




1. Align the bulb holder and bulb (2) with the keyed opening in the circuit board of the rear A/C-heater control (1).
2. Insert the bulb holder and bulb straight into the circuit board until the bulb holder is firmly seated.
3. Using a small thin-bladed screwdriver, rotate the bulb holder clockwise about 30 degrees on the circuit board to lock it into place.
4. Reinstall the rear A/C-heater control onto the center floor console.
5. Reconnect the battery negative cable.