LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2004 >> Durango 2WD V8-5.7L VIN D >> Repair and Diagnosis >> Starting and Charging >> Power and Ground Distribution >> Power Distribution Module >> Service and Repair >> Removal and Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal and Installation




REMOVAL
1. Disconnect the negative and positive battery cables.
2. Unsnap cover and remove the B+ terminal nut from the integrated power module (IPM). Remove the B+ cable.
3. Remove the IPM from the retaining bracket (1).
4. Disconnect the connectors from the (IPM).
5. Remove the Front Control Module (FCM) (2) retaining screws.
6. Disconnect the front control module by pulling it straight off the integrated power module.





INSTALLATION
1. Install the Front Control Module (FCM) (2) to the Integrated Power Module (IPM).
2. Connect the electrical connectors to the IPM (1).
3. Install the IPM to the retaining bracket.
4. Install the B+ cable and nut on the IPM B+ terminal. Snap the cover in place.
5. Connect the negative and positive battery cables.
scientia non olet · About LEMON Manuals