LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2004 >> SRT-4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Electronic Control Modules) >> Sentry Key Immobilizer Module >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sentry Key Immobilizer Module: Installation

WARNING: This page is about a different car, the 2004 Dodge SX and 2004 Dodge Neon. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If the SKIM is replaced with a new unit, a DRB III®scan tool MUST be used to initialize the new SKIM and to program at least two Sentry Key transponders (Refer to STANDARD PROCEDURE - SENTRY KEY IMMOBILIZER SYSTEM INITIALIZATION ).
  1. Place the SKIM into position.
  2. Rotate the SKIM and its mounting bracket downwards and then to the side towards the steering column (Figure).
  3. Install the two screws securing the SKIM to the top of the steering column (Figure).
  4. Engage the steering column wire harness to the Sentry Key Immobilizer Module (SKIM) (Figure).
  5. Install the steering column upper and lower shrouds. Refer to INSTALLATION .
  6. Install the Lower Instrument Panel Cover.
  7. Connect the battery negative cable.
scientia non olet · About LEMON Manuals