LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2004 >> SRT-4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Electronic Control Modules) >> Sentry Key Immobilizer Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sentry Key Immobilizer Module: Removal

WARNING: This page is about a different car, the 2004 Dodge SX and 2004 Dodge Neon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative remote cable.
  2. Remove Lower Instrument Panel Cover.
  3. Remove the steering column upper and lower shrouds. Refer to UPPER SHROUD .
  4. Disengage the steering column wire harness from the Sentry Key Immobilizer Module SKIM to (Fig 1).
  5. Remove the two screws securing the SKIM to the top of the steering column (Fig 1).
  6. Rotate the SKIM and its mounting bracket upwards and then to the side away from the steering column to slide the SKIM antenna ring from around the ignition switch lock cylinder housing (Fig 1).
    Fig 1: Removing/Installing Sentry Key Immobilizer Module (SKIM)
    G03537696Courtesy of DAIMLERCHRYSLER CORP.
  7. Remove the SKIM from the vehicle.
scientia non olet · About LEMON Manuals