Seat Temperature Control Module: Service and Repair
MODULE-HEATED SEATREMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open the liftgate and remove the upper D-pillar trim from the vehicle.
3. Remove the lower D-pillar trim from the vehicle.
4. Disconnect the wire harness connector from the back of the heated seat module (2).
5. Unsnap the heated seat module (2) from the D-pillar (1).
6. Remove the heated seat module (2) from the vehicle.
INSTALLATION
1. Install the heated seat module on the D-pillar (1).
2. Connect the wire harness connector (3) to the heated seat module (2).
3. Reconnect the negative battery cable.
4. Check for proper heated seat system operation.
5. Install the upper and lower D-pillar trim to the vehicle.
6. Connect the battery negative cable.