Ignition System (Service Information): Switch-Ignition: Installation

Fig 1: Ignition Switch & Screws

Courtesy of DAIMLERCHRYSLER CORP.

1. Before installing ignition switch (1), rotate the slot in the switch to the ON position.
2. Connect the electrical connector to rear of the ignition switch. Make sure that locking tabs are fully seated into wiring connector.
3. Position switch to column and install the mounting screws (2). Tighten screw to 3 N.m (26 in. lbs.).
   Fig 2: Ignition Switch & Bracket

   Courtesy of DAIMLERCHRYSLER CORP.
4. Install the tilt lever bracket (2) mounting screws. Tighten screws to 4.5 N.m (40 in. lbs.).
5. Position the wire retainer into the tilt lever bracket.
6. Reconnect the lower clockspring connectors.
   Fig 3: Locating Steering Column Opening Reinforcement Moun ting Bolts

   Courtesy of DAIMLERCHRYSLER CORP.
7. Install the steering column opening reinforcement (1).
   Fig 4: Locating Steering Column Opening Cover

   Courtesy of DAIMLERCHRYSLER CORP.
8. Install the steering column opening cover (2).
   Fig 5: Locating Key Cylinder And Key

   Courtesy of DAIMLERCHRYSLER CORP.
9. Install the key cylinder (1) with the key (2) in the cylinder (1).
   Fig 6: Tilt Lever Knob & Shrouds

   Courtesy of DAIMLERCHRYSLER CORP.
10. Install steering column upper and lower shrouds (2).
11. Install the tilt lever knob (1).
12. Enable the airbag system. Refer to RESTRAINTS - SERVICE INFORMATION .