Powertrain Verification Test VER-1

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Dodge Grand Caravan, 2002 Dodge Caravan, 2002 Chrysler Voyager, 2002 Chrysler Town & Country, and 2001 Dodge Grand Caravan. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If replacing Powertrain Control Module (PCM), the correct vehicle mileage and Vehicle Identification Number (VIN) must be programmed into PCM to prevent Diagnostic Trouble Codes (DTC) from being stored in Controller Anti-Lock Brake (CAB), Smart Key Immobilizer Module (SKIM), if equipped and Occupant Restraint Controller (ORC). If replacing PCM and vehicle is equipped with a SKIM, secret key data must also be updated to enable engine starting.

Inspect vehicle to ensure all engine components are connected. Reassemble and reconnect components as necessary. If repair procedure did not include replacing PCM, go to next step. If PCM has been replaced and has already been programmed, go to next step. If PCM has been replaced but has not been programmed, program PCM and clear DTCs. See PROGRAMMING . After PCM has been programmed, go to next step.
Inspect engine oil for fuel contamination. Change engine oil and filter as necessary. Attempt to start engine. If engine starts and stays running, go to next step. If engine does not start, check for related technical service bulletins. If necessary, go to TROUBLE SHOOTING - NO CODES - CARAVAN, TOWN & COUNTRY, & VOYAGER article for additional testing.
Allow engine to reach normal operating temperature. Using scan tool, verify that additional DTCs are not set and all components are operating properly. If any DTCs are set, perform appropriate diagnostic test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS in SELF-DIAGNOSTICS - CARAVAN, TOWN & COUNTRY, & VOYAGER article.