Charging System (Service Information): Generator: Installation: 2.0L/2.4L

Fig 1: GENERATOR REMOVAL

Courtesy of CHRYSLER LLC

1. Move A/C compressor to the side to install generator.
   Fig 2: ROTATE GENERATOR

   Courtesy of CHRYSLER LLC
2. Rotate generator and set in place.
   Fig 3: BATTERY STUD LOCATION

   Courtesy of CHRYSLER LLC

   Make sure battery terminal (1) is in front of A/C line (2).

   Fig 4: LOWER MOUNTING BOLT

   Courtesy of CHRYSLER LLC
3. Loose install lower mounting bolt.
   Fig 5: UPPER MOUNTING BOLT

   Courtesy of CHRYSLER LLC
4. Loose install upper mounting bolt.
5. Tighten bolts to GAS 54 N.m (40 ft. lbs.) or DIESEL 26 N.m (19 ft. lbs.).
   Fig 6: BATTERY CABLE CONNECTION

   Courtesy of CHRYSLER LLC
6. Install the B+ terminal nut and wire and tighten to GAS & DIESEL 10 N.m (88.5 in. lbs.).
   Fig 7: FIELD CONNECTION

   Courtesy of CHRYSLER LLC
7. Plug in the field circuit to the generator.
   Fig 8: IDLER PULLEY REMOVAL/INSTALL

   Courtesy of CHRYSLER LLC
8. Install idler pulley and tighten bolt.
9. Install the accessory drive belt.
10. Install splash shield.
    Fig 9: LOWER AIR DAM

    Courtesy of CHRYSLER LLC
11. Install lower air dam.
12. Lower vehicle.
13. Connect the negative battery cable.