Erasing Transmitter Codes

WARNING: This page is about a different car, the 2012 Dodge Challenger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Individual channels cannot be erased. Erasing the transmitter codes will erase ALL programmed codes.

To erase programming from the three buttons (individual buttons cannot be erased but can be "reprogrammed" - note below), follow the step noted:

Press and hold the two outer HomeLink® buttons and release only when the Electronic Vehicle Information Center (EVIC) display shows "Channels Cleared" (after 20 seconds). Release both buttons. Do not hold for longer that 30 seconds. HomeLink® is now in the train (or learning) mode and can be programmed at any time. Refer to STANDARD PROCEDURE .