LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2008 >> Nitro SLT, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> DTCS P2314 To U1418, System Checks, O2 Sensor Check, Checking Pcm Power And Ground Circuits, Engine Cranks But No Start >> U1412-Implausible Vehicle Speed Signal Received >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. ACTIVE DTC 

    Ignition on, engine not running.

    With a scan tool, select View DTCs.

    Is the U1412-IMPLAUSIBLE VEHICLE SPEED SIGNAL RECEIVED Active at this time? 

    Yes 

    1. Go To  2.

    No 

    1. Refer to the INTERMITTENT CONDITION Diagnostic Procedure.
  2. U0001-NO COMMUNICATION ON THE CAN C BUS CIRCUIT IS ACTIVE 

    Continue reading DTCs.

    Is the U0001-NO COMMUNICATION ON THE CAN C BUS CIRCUIT ACTIVE at this time? 

    Yes 

    1. Refer to the Diagnostic Procedure for the U0001-CAN C BUS .

    No 

    1. Go To  3.
  3. ABS MODULE IS ACTIVE ON THE CAN C BUS 

    With the scan tool, select ECU View.

    Verify that the ABS Module active on the bus.

    Is the ABS Module Active on the bus? 

    Yes 

    1. Go To  4.

    No 

    1. Refer to DIAGNOSIS AND TESTING for No Response diagnostic procedures.
    2. Perform BODY VERIFICATION TEST - VER 1 .
  4. ACTIVE DTCS IN THE TIPM 

    With the scan tool, select ECU View and select TIPM.

    With the scan tool, read active DTCs.

    Is the U0001-NO COMMUNICATION ON THE CAN C BUS CIRCUIT ACTIVE in the TIPM at this time? 

    Yes 

    1. Replace the ABS Module per Service Information.
    2. Perform POWERTRAIN VERIFICATION TEST .

    No 

    1. Replace and program the Powertrain Control Module per Service Information.
    2. Perform POWERTRAIN VERIFICATION TEST .
scientia non olet · About LEMON Manuals