LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2009 >> Caliber R/T, ED3, Standard >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Transmission Control Module (TCM) - Electrical Diagnostics >> DTC Troubleshooting >> U1428-Received Engine Torque Request Signal Stuck >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. CHECK IF THE DTC IS ACTIVE 
    1. With the scan tool, read Transmission DTCs.

      Is the status Active for this DTC?

      Yes 

      • Go to step  2

      No 

      • Go to step  5
  2. CHECK FOR FCM/TIPM CAN BUS DTCS 
    1. With the scan tool, read FCM/TIPM DTCs.

      Are there any FCM/TIPM CAN BUS DTCs present?

      Yes 

      No 

      • Go to step  3
  3. CHECK IF ENGINE DTCS ARE PRESENT 
    1. With the scan tool, read engine DTCs.

      Are there any engine DTCs present?

      Yes 

      No 

      • Go to step  4
  4. CHECK THE PCM 
    1. Replace and program the PCM in accordance with the Service Information. Refer to Electrical/Electronic Control Modules/MODULE, Powertrain Control - Removal
    2. Perform CVT VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure 

      Does the DTC reset?

      Yes 

      No 

      • Test Complete.
  5. CHECK THE WIRING AND CONNECTORS 
    1. The conditions necessary to set this DTC are not present at this time.
    2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
    3. Wiggle the wires while checking for shorted and open circuits.

      Were there any problems found?

      Yes 

      No 

      • Test Complete.
scientia non olet · About LEMON Manuals