Satellite Video Module - Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Connect antenna and electrical harness connector to module.
2. Install module to mounting bracket. Tighten mounting fasteners.
3. Position module and bracket. Install new mounting fasteners.
4. Install headliner.
5. Connect battery negative cable.