LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2009 >> Durango Base, 3.7 K >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Final Drive Control Module (FDCM) - Electrical Diagnostics >> DTC Troubleshooting >> C1404-Transfer Case Range Position Sensor Circuit Low >> Possible Causes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Possible Causes

Possible Causes 
INTERMITTENT TRANSFER CASE RANGE POSITION SENSOR CIRCUIT LOW
(K504) DRIVETRAIN 5 VOLT SUPPLY CIRCUIT OPEN
(K504) DRIVETRAIN 5 VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE
(T313) MODE SENSOR SIGNAL CIRCUIT OPEN
(T313) MODE SENSOR SIGNAL CIRCUIT SHORTED TO GROUND
TRANSFER CASE ENCODER
FINAL DRIVE CONTROL MODULE (FDCM)
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury. Refer to Electrical - Engine Systems/Battery System - Warning