Diagnostic Test

ANTI-LOCK BRAKE SYSTEM (ABS) MODULE DTCS PRESENT
NOTE: Verify the fluid level is correct and not contaminated before continuing with this test.
1. Ignition on, engine not running.
2. With the scan tool, read DTCs in the ABS Module.
  Are there any ABS DTCs present?
  
  Yes
  - Perform the appropriate ABS diagnostic procedure before continuing with this test. Refer to DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Diagnosis and Testing .
  No
  - Go to 2
HYBRID CONTROL PROCESSOR (HCP) DTCS PRESENT
1. With the scan tool, read DTCs in the HCP.
  Are there any HCP DTCs present?
  
  Yes
  - Perform the appropriate HCP diagnostic procedure before continuing with this test. Refer to DTC-Based Diagnostics/PROCESSOR, Hybrid Control (HCP) - Diagnosis and Testing .
  No
  - Go to 3
DTC IS ACTIVE
NOTE: Check with customer on driving terrain (e.g. mud, sand, snow) for set condition.
1. Ignition on, engine not running.
2. With the scan tool, record and erase DTCs.
3. Test drive vehicle on dry paved road.
4. With the scan tool, read DTCs.
  Is the status Active for this DTC?
  
  Yes
  - Go to 4
  No
  - Go to 6
RELEARN KISS POINT
1. Ignition on, engine running.
2. Place the transmission in neutral and apply the brakes firmly.
3. With the scan tool, run the FDCM non-volatile reset command.
4. Place the Transmission in park.
5. Turn the ignition off to the lock position
6. Wait for 10 seconds and turn ignition switch back to Ignition on, engine not running.
7. With the scan tool, erase DTCs.
8. Test drive vehicle on dry paved road.
9. With the scan tool, read DTCs.
  Is the DTC status Active?
  
  Yes
  - Go to 5
  No
  - Go to 6
TRANSFER CASE ENCODER
1. With the scan tool monitor the Transfer Case Encoder voltage while test driving the vehicle and performing 90° angle parking lot maneuvers in both forward and reverse.
2. Transfer Case Encoder voltage should be:
- 2WD - less than 1.5 volts
- 4WD - between 1.5 volts and 4.0 volts
INTERMITTENT WIRING HARNESS AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring harness and connectors specific to this circuit.
3. Wiggle test the wiring harness and connectors while checking for shorted and open circuits.
4. Using the scan tool, monitor the data related to this circuit while performing the wiggle test. Look for the data to change or for the DTC to reset.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the TRANSFER CASE VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Final Drive Control (FDCM) - Standard Procedure .
  No
  - Test complete.