Diagnostic Test
- CHECK FOR DTC U0402-IMPLAUSIBLE DATA RECEIVED FROM TCM NOTE: This DTC must be active for the results of this test to be valid.
- Ignition on, engine mot running.
- With the scan tool, record and erase DTCs.
- Cycle the ignition switch from off to on.
- With the scan tool, read DTCs.
Does the scan tool display: U0402-IMPLAUSIBLE DATA RECEIVED FROM TCM?
Yes
- Go to 2
No
- Refer to Non-DTC Diagnostics/Communication - Diagnosis and Testing and perform the Lost Stored Communication DTC diagnostic procedure.
- CHECK IF FCM CAN BUS DTCS ARE PRESENT
- With the scan tool, read FCM DTCs.
Are there any FCM CAN BUS DTCs present?
Yes
- Perform the appropriate diagnostic procedure. Refer to DTC-Based Diagnostics/MODULE, Front Control (FCM) - Diagnosis and Testing .
No
- Go to 3
- With the scan tool, read FCM DTCs.
- CHECK IF TRANSMISSION DTCS PRESENT NOTE: This DTC must be active for the results of this test to be valid.
- With the scan tool, read DTCs in the TCM.
Are there any Transmission DTCs present?
Yes
- Perform the appropriate diagnostic procedure. Refer to DTC-Based Diagnostics/MODULE, Transmission Electronic Hydraulic Control (TEHCM) - Diagnosis and Testing .
No
- Using the schematics as a guide, check the Final Drive Control Module (FDCM) pins, terminals, and wiring harness connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the Final Drive Control Module (FDCM) in accordance with the Service Information.
- Perform the TRANSFER CASE VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Final Drive Control (FDCM) - Standard Procedure .
- With the scan tool, read DTCs in the TCM.