LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2009 >> Durango Base, 3.7 K >> Repair and Diagnosis >> Transmission >> Transfer Case >> Final Drive Control Module (FDCM) - Electrical Diagnostics >> DTC Troubleshooting >> C1476-Transfer Case Clutch Position Out Of Range >> Possible Causes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Possible Causes

Possible Causes 
TRANSFER CASE KISS POINT NOT LEARNED
(T315) MOTOR B CIRCUIT OPEN OR HIGH RESISTANCE
(T316) MOTOR C CIRCUIT OPEN OR HIGH RESISTANCE
(K504) DRIVETRAIN 5 VOLT SUPPLY CIRCUIT OPEN OR HIGH RESISTANCE
(T313) MODE SENSOR SIGNAL CIRCUIT OPEN OR HIGH RESISTANCE
(K594) DRIVETRAIN SENSOR RETURN CIRCUIT OPEN OR HIGH RESISTANCE
TRANSFER CASE
FINAL DRIVE CONTROL MODULE (FDCM)
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury. Refer to Electrical - Engine Systems/Battery System - Warning