Powertrain Control Module - Installation

INSTALLATION - NGC CONTROLLER






NOTE: USE THE SCAN TOOL TO REPROGRAM THE NEW POWERTRAIN CONTROL MODULE (PCM) WITH THE VEHICLES ORIGINAL IDENTIFICATION NUMBER (VIN) AND THE VEHICLES ORIGINAL MILEAGE. IF THIS STEP IS NOT DONE, A DIAGNOSTIC TROUBLE CODE (DTC) MAY BE SET.

1. Install PCM to bracket with 3 fasteners (1).





2. Install and lock the 4 electrical connectors to the PCM.
3. Connect negative battery cable, tighten nut to 5 Nm (45 in. lbs.).
4. Use the scan tool to reprogram new PCM with vehicles original Identification Number (VIN) and original vehicle mileage.