Restraints System Verification Test

For complete wiring diagrams, refer to SYSTEM WIRING DIAGRAMS .

NOTE: If the ORC has been replaced, the ORC Initialization Procedure must be performed to clear the ORC Unlocked DTC and bring the module to a full state of readiness. Refer to the DTC list.

NOTE: Remove any special tools or jumper wires and reconnect all previously disconnected components - except the Battery.

WARNING: Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

Connect the scan tool to the Data Link Connector - use the most current software available.
With the scan tool, erase stored DTC in all airbag system modules.
Turn the ignition off, and wait 15 seconds, then turn the ignition on.
Note: If equipped with an Airbag On - Off switch, read the DTC in all switch positions.
Exercise the Restraints System to duplicate the appropriate monitor conditions for any DTC that were set
Wait one minute, and read active codes, if there are none present, read the stored codes.
If the scan tool shows any active or stored codes, return to DIAGNOSTIC CODE INDEX and follow the path specified for that trouble code. If no active or stored codes are present, the repair is complete.
Are any DTC present or, is the original condition still present?

Yes
- See DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Diagnosis and Testing and perform the appropriate diagnostic procedure.
No
- Repair is complete.