Diagnostic Procedure
- Connect the scan tool to the Data Link Connector (DLC).
- Reconnect any disconnected components.
- With the scan tool, erase all Transmission and Engine Diagnostic Trouble Codes (DTCs).NOTE: Erase DTC P0700 under engine to turn off the MIL light after completion of transmission repairs.
- If the Transmission has been repaired (Valve body/Controller replacement or if the Clutch assembly has been replaced), it is necessary to perform a Quick Learn (Teach-in) procedure with the scan tool.
- If the Powertrain Control Module (PCM), Front Control Module (FCM) or Totally Integrated Control Module (TIPM) has been replaced you must reset the Pinion Factor in the Front Control Module.
- With the scan tool, display Transmission Temperature. Start and run the engine until the Transmission Temperature is HOT, above 43° C (110° F).
- Check the transmission fluid and adjust if necessary. Refer to the Service Information for the Fluid Fill procedure.
- For a specific DTC, drive the vehicle to the symptoms When Monitored/Set condition(s) to verify the DTC is repaired.
- Check for any DTCs during and after the road test.
Did any DTCs set during the road test?
Yes
- See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Diagnosis and Testing and perform the appropriate diagnostic procedure(s).
No
- Repair is complete.