Diagnostic Test

CHECK IF THE DTC IS ACTIVE
1. With the scan tool, read Transmission DTCs.
  Is the status Active or is the Starts Since Set counter 2 or less for this DTC?
  
  Yes
  - Go To 2.
  No
  - Go To 4.
CHECK FOR FCM/TIPM CAN BUS DTCS
1. With the scan tool, read FCM DTCs.
  Are there any FCM/TIPM CAN BUS DTCs present?
  
  Yes
  - Refer to DTC Based Diagnostics and perform the appropriate diagnostic procedure.
  - Perform CVT VERIFICATION TEST. Refer to Standard Procedure .
  No
  - Go To 3.
CHECK IF ABS DTCS ARE PRESENT
1. With the scan tool, read ABS DTCs.
  Are there any ABS DTCs present?
  
  Yes
  - Refer to DTC Based Diagnostics and perform the appropriate diagnostic procedure.
  - Perform CVT VERIFICATION TEST. Refer to Standard Procedure .
  No
  - Using the diagrams as a guide, check the Transmission Control Module (TCM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM in accordance with the Service Information.
  - Perform CVT VERIFICATION TEST. Refer to Standard Procedure .
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the diagrams as a guide, inspect the wiring and connectors specific to this circuit.
3. Wiggle the wires while checking for shorted and open circuits.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform CVT VERIFICATION TEST. Refer to Standard Procedure .
  No
  - Test Complete.